Oct 27, 2022 Leave a message

Failure Mode Of Gear

1. Tooth surface wear

For open gear transmission or closed gear transmission with dirty lubricating oil, due to the relative sliding between the meshing tooth surfaces, some hard abrasive particles enter the friction surface, which changes the tooth profile and increases the backlash, so that the gear is excessively thinned and causes tooth fracture. In general, only when abrasive particles are mixed in the lubricating oil, will the gear surface be worn by abrasive particles during operation.

2. Tooth surface gluing

For high speed and heavy load gear transmission, due to the large friction between the tooth surfaces and the large relative speed, the temperature of the meshing area is too high. Once the lubrication condition is poor, the oil film between the tooth surfaces will disappear, making the metal surfaces of the two gear teeth directly contact, thus causing mutual adhesion. When the two tooth surfaces continue to move relative to each other, the harder tooth surface will tear off some materials on the softer tooth surface along the sliding direction to form grooves.

3. Fatigue pitting

When the two meshing gear teeth contact, the force and reaction force between the tooth surfaces cause contact stress on the two working surfaces. Because the position of the meshing point changes and the gear moves periodically, the contact stress changes in a pulsating cycle. Under the action of this alternating contact stress for a long time, small cracks will appear at the tool mark of the tooth surface. As time goes on, this kind of crack will gradually expand laterally on the surface. After the crack forms a ring, the surface of the gear tooth will produce a small area of peeling off and form some fatigue pits.

4. Broken gear teeth

The gear bearing load in the operation project is like a cantilever beam. When the periodic stress at the root of the gear subjected to pulse exceeds the fatigue limit of the gear material, cracks will occur at the root and gradually expand. When the remaining part cannot bear the transmission load, tooth fracture will occur. The gear may also be broken due to severe impact, eccentric load and uneven material.

5. Plastic deformation of tooth surface

Under the impact load or heavy load, the tooth surface is easy to produce local plastic deformation, which makes the surface of the involute tooth profile deformed.


Send Inquiry

whatsapp

Phone

VK

Inquiry