Oct 10, 2024 Leave a message

Cleaning, Inspection And Insulation Pad Requirements Of Bearings

Cleaning, inspection and insulation pad requirements of bearings


1. Cleaning and inspection of bearings


Large motor bearings are shipped separately in boxes. After unpacking, first use the eye screw to take out the upper and lower bearings, mark them and clean them with kerosene, wipe them with a dry cloth and check whether all grooves are clean, whether there is residual sand from casting, whether the tungsten gold layer is not well combined with the bearing body, whether there are sand holes and other impurities in the grooves and cracks drawn, etc.). If it cannot be repaired, re-hang the tungsten gold.


2. Cleaning and inspection of the bearing seat


Before installing the bearing seat, it should also be thoroughly cleaned and inspected. Scrape the dirt from the inner cavity of the bearing seat with a scraper, wipe the dirt with a cloth dipped in gasoline or solvent, and check whether there are cracks and sand holes to prevent oil leakage during operation. The joint surface between the bearing cover and the bearing seat, and the joint surface between the bearing seat and the bearing oil retaining ring should be scraped and matched, and checked with a feeler gauge. The gap should not be greater than 0.03 mm. The surface of the bottom plate where the bearing seat is placed should also be cleaned, and there should be no bruises, rust and burrs. The screws and seat plate threads that fasten the bearing seat should be carefully checked, and the screws should be tightened to check whether they are too tight or bald.


3. Bearing insulation structure


Insulating pads or metal gaskets must be placed between the bearing and the bottom plate. The metal gaskets are used to adjust the horizontal position of the seat. To adjust the relative position of the motor and another motor or machine connected to it. The metal gasket is made of 0.08~3 mm metal sheet. The insulating pad is made of cloth laminate or glass fiber laminate. The purpose of placing the insulating pad is mainly to prevent the harm of shaft current. The insulating pad should be 5~10 mm wider than each side of the bearing seat and 3~10 mm thick. In addition to placing an insulating pad between the bearing and the bottom plate, the screws and stabilizers should also be insulated. The insulating gasket is made of 2~5 mm thick glass fiber cloth plate, and its outer diameter is 4~5 mm larger than the outer diameter of the iron washer. The oil pipe connection plate insulation pad connected to the bearing seat can be made of a rubber sheet with a thickness of 1 to 2 mm. After the insulated bearing seat is installed, the insulation resistance to ground should be checked and measured with a 500 volt megohmmeter. The resistance should be no less than 1 megohm.

Send Inquiry

whatsapp

Phone

VK

Inquiry