Oct 14, 2024 Leave a message

Maintenance And Care Of Bearing Seats

Maintenance and care of bearing seats


During the use of bearing seats, special attention should be paid to the following points:


(1) Use of bearing seat cooling system. When used correctly, the cooling water of the bearing seat not only prolongs the service life of the bearing seat, but also improves production efficiency. The material of the bearing seat is generally made of special bearing seat steel through various treatments. Even the best bearing seat steel has its limits of use, such as temperature. When the bearing seat is in use, if the mold temperature is too high, it is easy to cause cracks on the surface of the mold core early. Some bearing seats even have large-scale cracks before more than 2000 molds. In production, the mold core of the bearing seat even changed color because the temperature of the bearing seat was too high. After measurement, it even reached more than 400 degrees. Such a temperature is easy to crack when it encounters the state of mold release agent quenching. The products produced are also prone to deformation, strain, mold sticking, etc. When using cooling water for the bearing seat, the use of mold release agent can be greatly reduced, so that the operator will not use the mold release agent to lower the temperature of the bearing seat. The benefits are that it effectively extends the life of the bearing seat, saves the die-casting cycle, improves product quality, reduces the occurrence of mold sticking, tearing and aluminum sticking, and reduces the use of mold release agents. It can also reduce the loss of ejector pins and cores caused by overheating of the bearing seat.


(2) The bearing seat must be preheated at the beginning of production to prevent the cold bearing seat from suddenly encountering hot molten metal and causing cracks. More complex bearing seats can be preheated with a blowtorch, liquefied gas, and a mold temperature controller under good conditions. Simpler bearing seats can be preheated with slow injection.


(3) Cleaning the parting surface of the bearing seat is very troublesome and easy to overlook. The operator should thoroughly clean the parting surface of the bearing seat with kerosene. This can not only prevent the bearing seat from being squeezed, but also clear the exhaust groove on the bearing seat that is blocked by mold release agent residues or other dirt after cleaning, which is conducive to the discharge of gas in the cavity during injection and improves product quality.


(4) If the bearing seat is equipped with neutron control, it is absolutely forbidden to have a joint in the signal line between the die-casting machine and the bearing seat. The reason is very clear. In daily production, it is difficult to avoid water on the signal line, or the joint wrapping is easy to break, resulting in a short circuit with the machine tool. If a signal error is caused, the alarm will automatically stop and delay the time, and the signal will be disordered, causing the bearing seat to be damaged. Unnecessary losses will be caused. Pay attention to waterproofing of the travel switch

Send Inquiry

whatsapp

Phone

VK

Inquiry