Nov 09, 2022 Leave a message

Maintenance Of Chain Wheel

1. The tightness of the sprocket should be appropriate. Too tight will increase power consumption, and the bearing is easy to wear; The chain wheel is too loose and easy to jump and fall off. The tightness of the sprocket is: it is lifted or pressed from the middle of the sprocket, which is about 2% - 3% of the center distance between the two sprockets.

2. The sprocket shall be installed on the shaft without swing and skew. In the same drive assembly, the end faces of two sprockets should be in the same plane. When the center distance of the sprockets is less than 0.5m, the deviation can be 1mm; When the center distance of the sprocket is more than 0.5m, the deviation can be 2mm. However, it is not allowed to have the phenomenon of friction chain gear side. If the two wheels are offset too much, it is easy to cause chain breaking and accelerated wear. When replacing the sprocket, pay attention to check and adjust the offset.

3. When the sprocket is seriously worn, replace it with a new one and a new one at the same time to ensure good engagement. It is not allowed to replace a new sprocket or a new sprocket alone. Otherwise, it will cause poor engagement to accelerate the wear of new sprocket or new sprocket. When the tooth surface of the sprocket is worn to a certain extent, it should be turned over in time for use (referring to the sprocket used with adjustable surface) to extend the service time.

4. The new sprocket is too long or stretched after use, which is difficult to adjust. The chain link can be removed according to the situation, but it must be an even number. The chain link shall pass through the back of the chain wheel, the locking plate shall be inserted outside, and the opening of the locking plate shall face the opposite direction of rotation.

5. The sprocket shall be filled with lubricating oil in time during operation. The lubricating oil must enter the fitting clearance between the roller and the inner sleeve to improve the working conditions and reduce wear.

6. The old sprocket cannot be mixed with some new ones, otherwise it is easy to have impact in the transmission and break the sprocket.

7. When the machine is stored for a long time, the chain wheel should be removed and cleaned with kerosene or diesel oil, and then coated with engine oil or butter and stored in a dry place.


Send Inquiry

whatsapp

Phone

VK

Inquiry