The models of V-belts are:
ordinary type O A B C D E 3V 5V 8V, ordinary reinforced type AX BX CX DX EX 3VX 5VX 8VX, narrow V-belt SPZ SPA SPB SPC,strong narrow V-belt XPA XPB XPC; each model of V-belt specifies the cross-sectional dimensions of the V-belt.
The cross-sectional dimensions of type A V-belt are:
top width 13mm, thickness 8mm; the cross-sectional dimensions of type B V-belt are: top width 17MM, thickness 10.5MM; the cross-sectional dimensions of type C V-belt are: top width 22MM, thickness 13.5MM; the cross-sectional dimensions of type D V-belt are: top width 21.5MM, thickness 19MM; the cross-sectional dimensions of type E V-belt are: top width 38MM, thickness 25.5MM. Corresponding dimensions (width*height): O (10*6), A (12.5*9), B (16.5*11), C (22*14), D (21.5*19), E (38*25.5).
The national standard stipulates that there are seven types of V-belts:
O, A, B, C, D, E, and F. The corresponding pulley groove angles are 34°, 36°, and 38°. At the same time, the minimum diameter of the small pulley corresponding to each groove angle of each type of V-belt is stipulated, and the large pulley is not stipulated. The groove angle of the pulley is divided into 32 degrees, 34 degrees, 36 degrees and 38 degrees. The specific selection should be based on the groove type and base diameter of the pulley. The groove angle of the pulley is related to the diameter of the pulley.
The recommended pulley groove angles of different types of pulleys in different diameter ranges are as follows:
O-type pulleys are 34 degrees when the pulley diameter range is 50mm-71mm; 36 degrees when 71mm-90mm, and 38 degrees when >90mm;
A-type pulleys are 34 degrees when the pulley diameter range is 71mm-100mm, 36 degrees when 100mm-125mm, and 38 degrees when >125mm;
B-type pulleys are 34 degrees when the pulley diameter range is 125mm-160mm; 36 degrees when 160mm-200mm, and 38 degrees when >200mm;
For C-type pulleys, the angle is 34 degrees when the pulley diameter ranges from 200mm to 250mm, 36 degrees when the pulley diameter ranges from 250mm to 315mm, and 38 degrees when the pulley diameter ranges from 315mm to 38 degrees;
for D-type pulleys, the angle is 36 degrees when the pulley diameter ranges from 355mm to 450mm, and 38 degrees when the pulley diameter ranges from 450mm to 450mm;
for E-type pulleys, the angle is 36 degrees when the pulley diameter ranges from 500mm to 630mm, and 38 degrees when the pulley diameter ranges from 630mm to 630mm.




