Jan 30, 2023 Leave a message

Three Kinds Of Gear Failure Forms And Preventive Measures

1. Tooth surface gluing
The cause of tooth surface gluing: high-power soft tooth surface or high-speed and heavy-duty gear transmission, when the lubrication conditions are poor, tooth surface gluing (bite welding) damage is easy to occur, that is, part of the material on one tooth surface is glued to the other tooth surface However, pits are left on this tooth surface. In the subsequent meshing transmission, the excess material on this part of the glue is easy to cause scratches and grooves on other tooth surfaces, forming a vicious circle.
The place where tooth surface gluing occurs is the tooth top surface near the pitch line.
Tooth surface gluing occurs in high-speed and low-speed heavy-duty gears.
Preventive measures for tooth surface gluing include suitable lubricating oil, increasing hardness, reducing surface roughness value, and using gear materials with strong anti-gluing ability.
2. Tooth surface plastic deformation (flash)
Causes of tooth surface plastic deformation:
The gear with softer tooth surface is frequently started and seriously overloaded. Under the action of excessive friction between the tooth surfaces, the contact stress of the tooth surface will exceed the shear strength of the material, and the tooth surface material will enter a plastic state, resulting in plasticity of the tooth surface metal. The flow makes the tooth surface near the pitch circle of the driving wheel form a concave groove, and the tooth surface near the pitch circle of the driven wheel forms a convex edge, thus destroying the correct tooth shape. Sometimes "flash" can appear on the driven tooth surface of certain types of gears. In severe cases, the extruded metal fills the top gap, causing severe vibration and even fracture.
The plastic deformation of the tooth surface occurs when the driving wheel forms a concave groove, and the driven wheel tooth surface forms a convex edge.
Preventive measures for tooth surface plastic deformation include increasing tooth surface hardness, selecting lubricating oil with higher viscosity, and avoiding frequent starting and severe overload.
3. Broken teeth
Causes of tooth breakage:
Variable load (fatigue, overload), if due to sudden overload or impact overload, it is easy to produce overload fracture at the tooth root. Even if there is no impact overload condition, when the gear teeth are repeatedly loaded, fatigue cracks are prone to occur due to stress concentration, and gradually expand, resulting in fatigue fracture of the gear teeth at the tooth root. In addition, quenching cracks, grinding cracks, and excessive tooth thickness reduction after severe wear may cause fractures at any part of the gear teeth. Fracture of teeth is the most serious failure of gears, often causing equipment downtime.
Tooth breakage occurs in open gear drives and hardened closed gear drives.
The preventive measures for tooth breakage include selecting the appropriate magic and tooth width, using appropriate materials and heat treatment processes, and reducing the stress concentration at the tooth root.

Send Inquiry

whatsapp

Phone

VK

Inquiry