May 16, 2025 Leave a message

Inspection Roller Chain Method

Inspection roller chain method

Appearance inspection

1. Whether the inner/outer chain is deformed, cracked, or corroded.

2. Whether the pin is deformed or rotated, or corroded.

3. Whether the roller is cracked, damaged, or excessively worn.

4. Whether the joint is loose or deformed.

5. Whether there is abnormal noise or abnormal vibration during operation, and whether the chain is in good lubrication condition.

Accuracy inspection

1. The chain is cleaned before measurement.

2. The chain to be measured is surrounded by two sprockets, and the upper and lower sides of the chain to be measured should be supported.

3. The chain before measurement should stay for 1 minute under the condition of applying one-third of the minimum limit tensile load.

4. During measurement, apply the specified measurement load to the chain to tighten the upper and lower chains. The chain and sprocket should ensure normal meshing.

5. Measure the center distance between the two sprockets.

Chain elongation inspection

1. In order to remove the clearance of the entire chain, measure under a certain degree of pulling tension on the chain.
2. When measuring, in order to minimize the error, measure at 6-10 links.
3. Measure the inner L1 and outer L2 dimensions between the rollers of the link number to find the judgment dimension L=(L1+L2)/2.
4. Find the elongation length of the chain, and compare this value with the limit value of the chain elongation in the previous item.
Chain elongation = judgment dimension - reference length / reference length * 100%.
Reference length = chain pitch * number of links.

Send Inquiry

whatsapp

Phone

VK

Inquiry